Samson TROVIS 5724-8 Mounting And Operating Instructions page 7

Responsibilities of operating personnel
Operating personnel must read and understand these mounting and operating instructions as
well as the specified hazard statements, warning, and caution notes. Furthermore, the oper-
ating personnel must be familiar with the applicable health, safety and accident prevention
regulations and comply with them.
Referenced standards and regulations
The electric actuators with process controllers comply with the requirements of the European
Pressure Equipment Directive 2014/30/EU and 2014/34/EU. This declaration of conformity
is included in the Appendix of these instructions.
The electric actuators are designed for use in low-voltage installations.
Î For wiring, maintenance, and repair, observe the relevant safety regulations.
Referenced documentation
The following documents apply in addition to these mounting and operating instructions:
− Configuration Manual for TROVIS 5724-8 and TROVIS 5725-8 Electric Actuators with
Process Controllers u KH 5724-8
− Mounting and operating instructions of the valve on which the electric actuator is
mounted, e.g. for SAMSON valves:
u EB 5861 for Type 3260 Three-way Valve
u EB 5863 for Type 3226 Three-way Valve
u EB 5866 for Type 3222 Globe Valve
u EB 5868 for Type 3213 and Type 3214 Globe Valves
u EB 8111 for Type 3321 Globe Valve
u EB 8113 for Type 3323 Three-way Valve
u EB 8131 for Type 3531 Globe Valve for Heat Transfer Oil
u EB 8135 for Type 3535 Three-way Valve for Heat Transfer Oil
u EB 3018 for Type 42-36 E Pressure-independent Control Valve (PICV) with electric
actuator
EB 5724-8 EN
Safety instructions and measures
7