Status Modes
Display
6.4
Saving parameters
Parameters are automatically saved when the
from parameter edit mode to parameter view mode.
6.5
Parameter access
There are 3 levels of parameter access controlled by Pr 10. This determines which
parameters are accessible. See Table 6-1.
The setting of the user security Pr 25 determines whether the parameter access is read
only (RO) or read write (RW).
Table 6-1
Parameter access (Pr 10)
6.6
Security codes
Setting a security code allows view only access to all parameters.
A security code is locked into the drive when Pr 25 is set to any other value than 0 and
then LoC is selected in Pr 10. On pressing the
changed from LoC to L1 and Pr 25 will be automatically set to 0 so as not to reveal the
security code.
Pr 10 may be changed to L2 or L3 to allow view only access to parameters.
6.6.1
Setting a security code
•
Set Pr 10 to L2.
•
Set Pr 25 to the desired security code e.g. 5
•
Set Pr 10 to LoC.
•
Press the
•
Pr 10 will now be reset to L1 and Pr 25 will be reset to 0.
•
The security code will now be locked into the drive.
•
Security will also be set if the drive is powered down after a security code has been
set into Pr 25.
VFD66 User Guide
Issue Number: 2
Status
The drive is enabled and ready for a start command. The
Drive ready
output bridge is inactive.
The drive is inhibited because there is no enable command,
Drive inhibited
or the drive is inhibited during a trip reset.
Mains loss
The drive is in mains loss ride through mode.
Parameters accessible
L1
L2
L3
MODE key
M
www.johnsoncontrols.com
Explanation
MODE key is pressed when going
M
Pr 01 to Pr 10
Pr 01 to Pr 67
Pr 01 to Pr 95
MODE key, Pr 10 is automatically
M
25