Selecting And Changing Parameters - Johnson Controls VFD66 Drive User Manual

6.3

Selecting and changing parameters

This procedure is written from the first power up of the drive and assumes no terminals
NOTE
have been connected, no parameters have been changed and no security has been set.
Figure 6-2
Hold
for 2s
M
When in Status mode, pressing and holding the
change the display from displaying a speed indication to displaying load indication (or
output current) and vice versa.
Pressing and releasing the
parameter view mode. In parameter view mode, the display flashes between the
parameter number and the value of that parameter.
Pressing and releasing the
view mode to parameter edit mode. In parameter edit mode, the display shows the
value in the parameter.
Pressing the
parameter view mode. If the
status mode, but if either of the
parameter being viewed before the
key will change the display to the parameter edit mode again. This allows the user to
very easily change between parameter view and edit modes during commissioning /
start up of the drive.
24
STATUS MODE
Press and
hold for 2s
Press and
M M
release
PARAMETER VIEW MODE
Select parameter to view
Press
Parameter number displayed
Press and
M
release
PARAMETER EDIT MODE
Change parameter value
Press
Parameter value displayed
MODE key will change the display from status mode to
M
MODE key again will change the display from parameter
M
MODE key in parameter edit mode will return the drive to the
M
MODE key is pressed again then the drive will return to
M
www.johnsoncontrols.com
or
/
/
or
Parameters
saved
or
MODE key for 2 seconds will
M
up or down keys are pressed to change the
MODE key is pressed, pressing the
M
Press and
M
release
4 mins
timeout
Press and
M
release
MODE
M
VFD66 User Guide
Issue Number: 2