Mounting With Bt 300-1 Mounting Device; Mounting With M4 Fastening Screws - Leuze electronic BPS 307i Operating Instructions Manual

6.2.6

Mounting with BT 300-1 mounting device

Mounting of the BPS with a BT 300-1 mounting device is intended for rod mounting. For ordering informa-
tion see chapter 14; for dimensioned drawing see figure 13.12.
 Mount the BT 300-1 mounting device with the clamp profile on the rod (system-side).
 Mount the BPS on the mounting bracket of the BT 300-1 with M4 fastening screws (included in delivery
contents).
Maximum tightening torque of the M4 fastening screws: 2 Nm
6.2.7

Mounting with M4 fastening screws

Figure 6.11: Dimensioned drawing of rear of BPS
 Mount the BPS on the system with M4 fastening screws (not included in delivery contents).
Maximum tightening torque of the fastening screws: 2 Nm
Leuze electronic
all dimensions in mm
BPS 307i
Mounting and installation
42