Management; Advanced - TRENDnet TEW-840APBO User Manual

TRENDnet User's Guide

Management

Advanced

Management > Advanced
This page contains the SNMP, CLI, Telnet, SSH, and Email Alert configurations.
1. Log into your access point management page (see
management page" on page 29).
2. Click on Advanced under Management from the left side menu.
SNMP Settings

Status – Select Enable to enable SNMP. Default: Disabled

Contact – Enter the Contact for the SNMP in this field.

Location – Enter the Location for the SNMP in this field.

Port – Enter the Port for the SNMP in this field.

Community Name (Read Only) – Enter the community name designated with
Read Only permissions.

Community Name (Read Write) – Enter the community name designated with
Read Write permissions.

Trap Destination
o
Port – Enter the port number for the SNMP trap destination.
o
IP Address – Enter the IP address for the SNMP trap destination.
o
Community Name – Enter the community name for the SNMP trap
destination (defined above).

SNMPv3 Settings
o
Status – Select Enable to enable SNMPv3.
o
Username – Enter the username for the SNMPv3.
o
Authorized Protocol – Select the authorized protocol for the SNMPv3.
o
Authorized Key – Enter the key for the protocol specified above for
SNMPv3.
o
Private Protocol – Select the private protocol for the SNMPv3.
o
Private Key – Enter the private key for the protocol specified above for
SNMPv3.
o
Engine ID – Enter the engine ID.
© Copyright 2019 TRENDnet. All Rights Reserved.
"Access your access point
CLI Settings

Status – Select Enable to enable Telnet Command Line Interface. Default:
Disabled
SSH Settings

Status – Select Enable to enable Secure Shell Interface. Default: Disabled
TEW-840APBO / TEW-840APBO2K
38