TRENDnet User's Guide
Setup and Confirm Connectivity
1. Remove the cover of the access points by pulling and holding the tab outwards (as
shown in the picture below) and sliding the cover downwards, away from the
access point.
© Copyright 2019 TRENDnet. All Rights Reserved.
2. Using a RJ-45 network cable, connect one end of the cable to the LAN1 (PoE) port
and ensure the cable is lined up with the Cable Guides before closing the cover.
(note: this RJ-45 network cable cannot exceed 60m)
3. Connect the other end of the RJ-45 network cable to the PoE port on the included
PoE injector. (note: this RJ-45 network cable cannot exceed 60m)
4. Using another RJ-45 network cable, connect one end to the LAN port on the
included PoE injector.
5. Connect the other end of the RJ-45 network cable to your computer's Ethernet
port.
6. Attach the power cord to the PoE injector and plug the connected power cord into a
power outlet.
TEW-840APBO / TEW-840APBO2K
19