TRENDnet TEW-840APBO User Manual page 36

TRENDnet User's Guide
5GHz-802.11AC/N
Note: The following section will have different options bases on chosen Channel Access
Mode and Operation Mode of the access point.
The following example screenshot is of CSMA in Access Point mode.

Operation Mode – Select the desired operation mode from the drop down,
Access Point, Client Bridge, WDS Access Point, WDS Station, or
(CSMA only). For more information, see

Channel HT Mode – Select the desired channel HT mode from the dropdown;
80MHz (AC Only), 40MHz, or 20MHz.

Channel – Click Configuration, and select the channel from the pop-up
window. GREY options are selected, and BLUE options are not selected. Click
Save to save the channel, and switch back **if the pop-up window does not
appear, please disable the browser's ad/pop-up blocker**
© Copyright 2019 TRENDnet. All Rights Reserved.
WDS Bridge
"Application Mode" on page 26.
TEW-840APBO / TEW-840APBO2K

Transmit Power – Select the desired transmit power from the dropdown.

Bit Rate – Click Configuration, and select the bitrate using the slider in the pop-
up window. **if the pop-up window does not appear, please disable the
browser's ad/pop-up blocker**

Client Limits (CSMA Access Point Mode
maximum clients and select Enable/Disable

AP Detection – Click Scan to commence a network site survey of the
surrounding access points.

Distance – Enter in the distance (0-10 in km) between the access points. The
equivalent distance measured in miles is to the right of the field for your
convenience.

AP Time Slot – In TDMA mode, the access point will assign time slots for each
client's data transmission. The higher the value, the faster the data
transmission.

Station Priority – In TDMA mode, the client bridge/WDS station's data
transmission is prioritized by data. A higher level means a longer transmission
time. (the time ratio is 10:5:1 for High:Medium:Low)
only)– Enter the desired number of
34