Returning To Factory Settings; Feed - Star Micronics LaserPrinter 8III Operation Manual

_".^
-..
l
Press [ENTER], after which the screen will display
NV RAM LOAD DONE
l
Finally, press [ON LINE]. Your new settings are now saved, and you
can continue with other printing, if desired.
Returning to Factory Settings
If for some reason you want to start from the beginning, with the original
factory settings, follow this procedure:
l
In the Program mode, press [NEXT] until the screen reads
LOAD FACTORY SET
l
Press [ENTER]. The screen will display briefly
LOAD FROM ROM OK
then
REINITIALIZE
The factory settings are now restored, and you can go on line for other
activities.
MANUAL FEED
As the status sheet shows, the Star LaserPrinter 8111 come set for
automatic paper feed from the cassette. To change this setting from
the front panel, put the printer off line, and press
[PROGRAM].
l
Press [NEXT] until the screen displays:
PAPER FEED
l
Press [ENTER], and the screen will now display:
FEEDER
. Press [ENTER], which will display
Cassette
l
Press [NEXT] to display
Manual
55