Table of Contents
Advertisement
SERVICE CALL MESSAGES
Engine service call messages
Engine service call messages are related to the interface with tbe.engine.
They can result from either a communication failure, or a halt in the
engine's ready level.
1 MESSAGE
1 MEANING
1 RESULT
CALLSERVICE
t-
CALLSERVICE
improper communication processing stops; alarm beeps;
press DZRROR SKIP] to reset
engine and recheck
laser synchronization
processing stops; alann beeps;
problem
press [ERROR SKIP] to reset
engine and recheck
CALL SERVICE
03 scanner motor malfunc- processing stops; alarm beeps;
tion
press [ERROR SKIP] to reSet
engine and recheck
communication processing stops; alann beeps;
press [ERROR SKIF'] to reset
engine and recheck
Controller error messages result from failure in either hardware or software.
Some controller error messages occur during startup tests. The messages
mean that the controller is malfunctioning, but is still able to display the
error m,assage. Certain conditions can also be detected during controller
reset, on insertion of a cartridge, and at other times after the completion of
power-up initialization. An error stops the test sequence, the unit goes off
line, and the alarm sounds. The controller will attempt to recover, if
possible. If the problem is not found during initialization, but nxurs during
operation, most likely the fault is in the hardware.
-
-
-
92
Advertisement
Table of Contents
