Table of Contents
Advertisement
Safety Notices
This rinteriscertifiedasaClass
1 laserproductundertheU.S.Departmentof
HealthandHumanServices
(DHl?S) Radiation Performance
Standard according to the Radiation Control for Health and Safety Act
of 1968. This means that the printer does not produce hazardous
laser radiation.
Since radiation emitted inside the printer is completely confined within protective housings and external
covers, the laser beam cannot escape from the machine during any phase of user operation.
The Center for Devices and Radiological
Health (CDRH) of the U.S.Food and Drug Administration
implemented
regulations
for laser products on August 2,1976. These regulations
apply to laser products
marketed in the United Stales. The label on the printer indicates compliance
with the CDRH regulations
and must be attached to laser products marketed in the United States.
Caution-use
of controls or adjustments
or performance
of procedures
other than those specified herein
may result in hazardous
radiation exposure.
Federal Communications
Commission
Radio Frequency
Interference Statement
This equi
to Part 1 P
ment has been tested and found to comply with the limits for a Class B digital device, pursuant
of FCC Rules. These limits are designed to provide reasonable
protection
against harmful
interference
in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and. if not installed and used in accordance
with the instructions,
may cause harmful interference
to radio communications.
However, there is no guarantee that interference
will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
bedeterminedbytumingtheequipmentoffandon,~euserisencouraged
to trytocorrecttheinterference
by one or more of the following measures:
* Reorient or reloate the receiving antenna.
* Increase the separation between the equipment and receiver.
l
Connect the equipment
into an outlet on a circuit different from that to which the receiver is
connected.
* Consult the dealer or an experienced
radioKV
technician
for help.
For compliance
with the Federal Noise Interference
Standard, this equipment requires a shielded cable.
Tk above statemenls apply only to printers markled in lk U.S.A.
Self Declaration
Radio interference regarding this equipment has been eliminated according to Vfg 1056/1984 announced
by the DBP.
DBP has been informed of the introduction
of this special equipment and has been granted the right to
examine the whole series.
It is the user's res
nsibility to see that his own assembled system is in accordance
with the technical
T
regulations
under
fg 1046/1984.
To conform to FlZ-regulations
it is necessary to make all connections
to the printer with shielded cable.
The equipment may only be opened by qualified service representatives.
Tk above s~a~emenl applies only IO prinlers ma&led in West Germany.
-
-
-
-
Advertisement
Table of Contents
