Table of Contents
Advertisement
To make the setting permanent, you must save it in EEPROM! Perform this
programming
sequence, after taking the printer Off Line.
l
Press [PROGRAM].
l
Press [<I until the screen displays
SET USER DEFAULT
l
Press [v], after which the screen will display
MODE 1
l
Press [c] when you want to store the new setting to the other mode.
l
Press [v] when the desired mode is selected.
Now the screen will display
EEPROM LOAD DONE
l
Finally, press [ON LINE]. Yournew settings are now saved, and you can
continue with other printing, if desired.
4.3.4 Returning to Factory Settings
If for some reason you want to start from the beginning, with the original
factory settings, follow this procedure:
l
In the Program mode, press [<I until the screen reads
LOAD FACTORY SET
l
Press [v]. The screen will display
EC Set @
l
Pressing [-cl display the other option:
US Set
Select the one you want.
l
Press [v]. The screen will display briefly
LOAD FROM ROM OK
then
LOAD FACTORY SET
Tnk factory settings are now restored, and you can go On Line for other
activities.
52
-.
_-
-
-
-
-
Advertisement
Table of Contents
