Table of Contents
Advertisement
-
Place your finger on the arrow and slide the button forward, then press down
on it. The top of the printer will pop open slightly, just like the hood of an
automobile. The top has two open positions, one at about 45 degrees and the
other fully open. Lift the top to its fully open position, so you can see the
interior of the printer.
You must remove several pieces of packing material. The largest, a large
wedge of Styrofoam, is at the center front of the interior. Lift this out and
save it for future repacking.
L
Toward the back of the interior you will see a green lid with a warning label
in red lettering. On the left and right sides of this area are orange stabilizers.
Each stabilizer bears a tag with black lettering, telling you (in several
languages) to remove them. Grasp one of these and pull it down, then
forward in the direction of the arrows on the tag. Remove the second one
the same way. Save the stabilizers for future repacking.
10
-
-
Advertisement
Table of Contents
