Table of Contents
Advertisement
. Now press [NEXT] two times. The screen will change to
SERIAL
l
With the display reading
SERIAL,
this time press [ENTER]. The
screen will show
BAUD RATE
l
Pressing [ENTER] now displays
9600 baud
l
Press [NEXT] to display a series of options, from 300 to 19200. Keep
pressing until the one you want appears on the screen.
l
Pressing [ENTER] now displays
9600 baud @
l
Then press [EXIT] displays
BAUD RATE.
Pressing [NEXT] displays
these options:
DATA BIT
PARITY
STOP BIT
PROTOCOL
The settings from the factory for these options are:
8 bit
no parity
1 stop bit
XON/XOFF
Whenever you want to change any of the serial parameters, follow the same
sequence as for selecting the baud rate. For example, to change the data bit,
at
SERIAL
press [ENTER] then [NEXT] until
DATA BIT
is displayed on the
screen. Pressing [ENTER] will display the first option, and [NEXT] will
give the rest of them. Press [ENTER] when your choice appears on the
screen. Finally, press [ON LINE], which readies the Star LaserPrinter 8111
for printing.
-_
52
-
Advertisement
Table of Contents
