Program Menu - Kolver EDU 2AE/TOP Manual

MAIN MENU:
- - - - - M A I N - M E N U - - - - - -
O K
P r o g r a m
S e q u e n c e
Program setting: It indicates the menu section where you can set or modify the fastening
parameters.
To be allowed to enter this menu sequence and EXT options should be OFF.
Sequence: It indicates the menu section where you can activate the sequence,
tray and the bar code.
- - - - - M A I N - M E N U - - - - - -
S e q u e n c e
O p t i o n s
Options: It indicates the menu section where you can set date and time, the password and the
language.

PROGRAM MENU:

The first 25 menu lines are available in both the EDU 2AE/TOP and EDU 2AE/TOP/TA model.
Lines from 26 to 29 are only available in the TOP/TA model.
- - - - - M E N U - - P R : 1 - - - - -
O K
1 ) P r o g r a m n u m b e r :
2 ) S c r e w s
you can select the desired program 1 to 8.
1) Program number:
2) Screw number: The EDU2AE/TOP can act as screw counter.
from 1 to 99. To disable the function select OFF by pressing
If the number of correct screws is equal to the number of set screws "CYCLE END" will appear on the status
bar and the yellow led will light up. If the OK/ESC function is disabled (see point 23), "CYCLE END" will
automatically disappear at next screwing cycle or any time you enter the menu. Otherwise, press OK at the
end of each cycle.
ATTENTION: Every time you enter the menu, the number of screws will reset.
Manual EDU 2AE/TOP e EDU 2AE/TOP/TA Rev.0
c h a n g e
s e t t i n g
s e t t i n g
s e t t i n g
c h a n g e
n u m b e r :
E S C q u i t
E S C q u i t
You can set the number of screws
as many times as needed.
the switchbox/socket
1
1
Pagina 4