Kolver EDU 2AE/TOP Manual page 3

IMPORTANT: EDU 2AE/TOP is a highly accurate unit but it is critically important to select the
correct options to ensure that proper torque is being applied. Read the menu description carefully and
in case you are unsure please contact Kolver for support information.
Turn the unit on through the on/off switch on the back panel. The unit will carry a general system check and
the words "waiting connection" will appear on the last line of the display. If the connection with the motor
control board is successful the following screen will be displayed:
Press any key on the front panel to enter the main screen (see following picture).
P L U T O 1 0
P R : 1
T :
1- Reached torque level in Nm or in.lbs
2- Program number or sequence
3- Screwdriver model
4- Clock
5- Screw count: done screws/total screws
6- Angle value in degrees (only model EDU 2AE-TOP TA)
7- Status bar (ready, errors, etc...)
To enter the menu press the ESC key for 2 seconds.
Select the line by pressing
to select the required value and then confirm through the OK key (or ESC if you don't want to save the
value).
The selected values will be immediately operational, even if
the sequence for all the parameters you wish to change and then push the ESC key to return to the main
screen.
Press RESET key for 3 seconds should you need to reset the cycle.
If you want to see all the set parameters press key
displayed parameters on this screen.
Manual EDU 2AE/TOP e EDU 2AE/TOP/TA Rev.0
K o l v e r S . R . L .
E D U 2 A E
V e r s i o n
s y s t e m r e a d y
r e a d y
or then press OK (the symbol
T O P
1 . 0
1 0 : 0 0
S : 0 / 0 1
A :
will turn into
you are still in the menu screen.
for 2 seconds, however you cannot modify the
). Press the or key
Repeat
Pagina 3