Safety Instructions; Safety In General; Safety Warnings - Danfoss IKP1000 User Manual

User Manual
IKP1000 Transmitter

Safety instructions

IKP1000 General Safety
IKP1000 Safety Warnings
4 | © Danfoss | October 2019
The following safety instructions must be read carefully to install and use the product properly, and to
keep it in perfect working condition, and to reduce the risk of misuse.
•
Strictly adhere to the installation instructions contained in this document.
•
Make sure that professional and competent personnel carry out the installation.
•
Ensure that all site and prevailing safety regulations are fully respected.
•
Make sure that this document is permanently available to the operator and maintenance personnel.
•
Keep the transmitter out of reach of non-authorized personnel.
•
Remove the transmission key when the set is not in use.
•
Check each working day the STOP button and other safety measures. When in doubt, press the STOP
button.
•
Whenever several sets have been installed, make sure the transmitter is the right one. Identify the
machine controlled on the label for this purpose on the transmitter or by using the display (in case it
has one).
•
Service the equipment periodically.
•
When carrying out repairs, use spare parts supplied by Danfoss only.
W
Warning
Potential damage to the operator or the product. Do not use this product on machines in potentially
explosive atmospheres unless the model is ATEX/RATEX certified to work in such conditions.
•
Use the device with the manufacturer's battery and battery charger (if applicable).
•
Only allow qualified personnel to operate the equipment.
•
After use, do not leave any transmitter on. Always set the STOP button in the off position, which will
disconnect the transmitters. This will avoid any unintentional maneuvers – specially for crane
maintenance purposes.
•
Do not plug a tether cable while the transmitter is in operation mode. Always press STOP before
plugging in the tether cable.
•
Do not operate product when visibility is limited.
•
Make sure product is compatible with the machine.
•
Avoid knocking or dropping the product.
•
Do not use the equipment if a failure is detected.
BC319754051671en-000101