Install New Pump; Remove And Install Power Supplies; Remove Supply - Honeywell Vertex M Manual

Vertex M 24-Point Continuous Monitor
TM

5.6.2 Install New Pump

1. Slide pump assembly into enclosure.
2. Push pump completely into enclosure until
the release button locks into the bottom of the
enclosure.
4. Push on slideplate to re-install on to fitting
3. Close and fasten the pump enclosure door,
install filter, and close lower cabinet door.
Section 5 - Maintenance
Inlet
Note
Crossing of
Tubing
Outlet
5-12
WARNING
Adjacent pump may be hot. To avoid burns, allow to cool or
wear protective clothing before handling either pump.
5.7 Remove and Install
Power Supplies

5.7.1 Remove Supply

Two replaceable modules provide power for the Vertex
M System. A fully populated Vertex M will operate with
one supply. You may replace the defective supply while
the system continues to monitor.
Preparation
1. Open front door.
2. Identify inoperative power supply.
3. Turn locking knob counter-clockwise to
disengage catch.
4. Firmly pull power supply to remove from
housing.
Locking knob