Honeywell Vertex M Manual page 53

Communications
Symptom Problem
Incorrect network connection
Vertex M not appearing
on network
Windows not configured for network
ChemCam
Symptom Problem
No image from one or Defective camera
more ChemCam
Defective USB port
Poor image quality Camera settings are incorrect or illumination
LED has failed
Section 6 - Troubleshooting
Recovery
Check cable connection to Ethernet port
Note: Use only the Ethernet connection on the back of the data
acquisition computer. The Ethernet hub in the Vertex M System
is only for Vertex M internal use.
Use Windows Network control panel to configure network
Vertex M computer name is Vertex_293-xxxx
Default workgroup is "Workgroup"
Recovery
Contact Honeywell Analytics
Use any other spare USB port
Contact Honeywell Analytics
6-4