Adjusting The Dispense Plate - CAB HS Series Operator's Manual

4 Operation

4.2.6 Adjusting the Dispense Plate

The label material must run parallel to the chassis, failing this :
 Loosen screw (2).
 If the material (1) runs away from the chassis, pull the dispense plate a
little out of the guiding (4).
 If the material (1) runs against the chassis, push the dispense plate a little
into the guiding (4).
 Tighten screw (2) .
 Dispense several labels to test the material run.
Fig. 11 Material run
Fig. 12 Adjusting the dispense plate
2
3
2
3
1
2
3
17
4
2
3
1