Claims For Damage And Repackaging; Claims For Damage; Repackaging For Shipment Or Storage; Making Connections To The Intellivue G1/G5 - Philips M1013A IntelliVue G1 Service Manual

Claims for Damage and Repackaging

Claims for Damage and Repackaging

Claims for Damage

When the equipment is received, if physical damage is evident or if the IntelliVue G1/ G5 does not
meet the specified operational requirements of the patient safety checks or the extended self check,
notify the carrier and the nearest Philips Sales/Support Office at once. Philips will arrange for
immediate repair or replacement of the instrument without waiting for the claim settlement by the
carrier.

Repackaging for Shipment or Storage

If the instrument is to be shipped to a Philips Sales/Support Office, securely attach a label showing the
name and address of the owner, the instrument model and serial numbers, and the repair required (or
symptoms of the fault). If available and reusable, the original Philips packaging should be used to
provide adequate protection during transit. If the original Philips packaging is not available or reusable
please contact the Philips Sales/Support Office who will provide information about adequate
packaging materials and methods.

Making Connections to the IntelliVue G1/G5

All connections to the gas analyzer are made on its rear panel. Refer to Figure 2.
1
Figure 2 The Rear Panel
1 Local power connector; this is a 3-pin connector, used to connect the gas analyzer to AC Power.
The gas analyzer can be operated from an AC power source of 100 - 240 V ± 10%, 50/60 Hz. The
adjustment is made automatically by the power supply inside the module.
RS232 Connector (RS232 Interface); this is an RJ45 connector, used to connect the gas analyzer to
2
the monitor.
The connection to an IntelliVue patient monitor can be made with the following cables:
• For M1013A IntelliVue G1:
– M1013A#K11 1.5 m (M1013-61001)
– M1013A#K12 3 m (M1013-61002)
• For M1019A IntelliVue G5
3
2 Installation and Patient Safety
2
4
5
17