Nmea Data Page; Nmea Depth, Wind Speed, Temp And Sog Trend - Standard Horizon CP180 Owner's Manual

The NMEA sentences read from external devices are: BWC, DSC, DSE, GGA, GLL, GSA,
GSV, HDG, HDM, HDT, RMC, VHW, VTG, DPT, DBT, MTW, VWR, VWT, TLL, WPL, RTE.
CHANGING the NMEA PAGE Windows
1. Press [MENU]. Move the ShuttlePoint knob to highlight NMEA DISPLAY and press
[ENT].
2. Move the ShuttlePoint knob to highlight DISPLAY and press [ENT].
3. To change the 5 different pages move the ShuttlePoint knob to the left or right.
12.7

NMEA DATA PAGE

The NMEA Data Page is very useful to see if a External device (example: Depth Sounder)
is transmitting NMEA sentences to the GPS chart plotter. This page can also be used to see
if the GPS chart plotter NMEA output is being loaded down by a external NMEA device the
GPS chart plotter is connected to.
Scenario: VHF Radio connected but the Radio is not receiving a GPS Position.
Usually the VHF Radio will be connected to the Green and Brown wires. To check to see
if the GPS chart plotter is transmitting the sentences:
1. Press [MENU]. Move the ShuttlePoint knob to highlight NMEA DISPLAY and press
[ENT].
2. Move the ShuttlePoint knob to highlight DATA and press [ENT].
3. Connect the BLUE Wire on the GPS chart plotter to the junction of the Brown wire and
the VHF wire. The display should look similar to the picture below.
12.8 NMEA DEPTH, WIND SPEED, TEMP AND SOG TREND PAGES
When the GPS chart plotter is connected to the Optional FF520 50/200kHz BLACK BOX
CP180 / CP180i
Figure 12.6 - NMEA Display page
Figure 12.7 - NMEA Data page
Page 69