Standard Horizon CP180 Owner's Manual page 17

the following order: Start-up screen, DSC Polling page, GPS Status, Chart/General window,
Chart/Compass tape, Chart/Fish, Full page Fish, Navigation page, Highway Page, Celestial
page, NMEA Page.
This mode is use by selling dealers to promote the features of the CP180 and CP180i when
retail shelf.
The Demo mode can be selected from the Simulation Menu following the procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight SIMULATION and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight DEMO MODE and press [ENT] or move the
ShuttlePoint knob to the right to show the popup window.
5. Move the ShuttlePoint knob to select On and press [ENT] or move the ShuttlePoint knob
to the right.
6. Demo mode is now activated.
Once the Demo mode is enabled, pressing any key it is possible to temporally exit and
returns to GPS chart plotter normal operation, but if you do not touch any key for 30 seconds
Demo mode re-starts.
To disable Demo mode follow the procedure above selecting Off
CP180 / CP180i
NOTE
on a
at point 5.
Page 19