Advertisement
ISO DIN radio provision with pocket
1. Remove the metal DIN sleeve and trim
ring from the aftermarket radio
2. Secure the ISO DIN radio brackets to the
radio using screws supplied with the
radio. (Figure A)
3. Slide the radio into the radio housing
until it snaps into place. (Figure B)
4. Snap the ISO DIN trim plate onto the
front of the radio housing. (Figure C)
5. Snap the pocket into the radio housing.
(Figure D)
6. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio for proper operation.
7. Reassemble the dash in reverse order of
disassembly to complete the installation.
KIT ASSEMBLY
(Figure A)
(Figure C)
(Figure B)
(Figure D)
5
REV. 8/26/2019 INST99-7509
Advertisement
