Seat Switch - Toro Groundsmaster 4300-D Service Manual

Seat Switch

Testing the Seat Switch
Groundsmaster ® 4300-D
16226SL Rev C
g190802
1. Platform wire harness
g190803
1. Operator seat
2. Seat switch harness
The seat switch is normally open and closes when the operator is on the seat. If
the traction system or PTO switch is engaged when the operator raises out of the
seat, an operator advisory will be displayed on the InfoCenter. The seat switch
and its electrical connector are located directly under the operator seat
172). Testing of the switch can be done without seat removal by disconnecting
the switch wire from the platform wire harness
The Toro Electronic Controller (TEC) monitors the operation of the seat switch.
1. Park the machine on a level surface, lower the cutting decks, set the parking
brake, and shut off the engine.
Figure 171
2. Seat switch connector
Figure 172
3. Washer-head screw (2 each)
4. Seat switch
Page 5–61 Electrical System: Testing the Electrical Components
(Figure 171).
(Figure