Toro Groundsmaster 4300-D Service Manual page 266

Adjusting the Traction Neutral Switch (continued)
Electrical System: Adjustments
Note: To prevent the traction neutral switch damage, ensure that the pump
lever does not contact the switch.
2. When the traction pedal is in the N
of the neutral switch and the pump lever should be 3.05 to 3.55 mm (0.12
to 0.14 inch) (Figure
3. If gap is incorrect, loosen the jam nuts that secure the neutral switch to the
pump plate. Position the switch with jam nuts to allow correct gap between
the switch and the pump lever. Torque the jam nuts to 18 to 22 N∙m (159 to
195 in-lb). After the jam nuts are tightened, ensure that clearance between
the head of the neutral switch and the pump plate has not changed.
4. After adjustment to the traction neutral switch, use the InfoCenter display
to verify that the traction neutral switch and circuit wiring are functioning
correctly; refer to Using the InfoCenter Display for Troubleshooting (page
5–26).
position, the gap between the head
EUTRAL
151).
Page 5–42 Groundsmaster ® 4300-D
16226SL Rev C