Steering Cylinder - Toro Groundsmaster 4300-D Service Manual

Steering Cylinder

g195114
1. Grease fitting
2. Hydraulic hose
3. O-ring (2 each)
4. 90° hydraulic fitting
(2 each)
Removing the Steering Cylinder
Groundsmaster ® 4300-D
16226SL Rev C
5. O-ring (2 each)
6. Hydraulic hose
7. 90° grease fitting
8. Retaining ring
1. Park the machine on a level surface, lower the cutting decks, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Read the General Precautions for Removing and Installing the Hydraulic
System Components (page
Figure 119
9. Ball joint
10. Rear axle
11. Jam nut (2 each)
12. Cotter pin
4–87).
Page 4–155
13. Slotted hex nut
14. Right drag link
15. Steering cylinder
16. Ball joint
Hydraulic System: Service and Repairs