About Screen - Toro Groundsmaster 4300-D Service Manual

Settings Screen (continued)

About Screen

Groundsmaster ® 4300-D
16226SL Rev C
after the correct passcode (PIN) has been entered (refer to the Protected Menus
in the Settings Screen (page
Counterbalance: Controls the amount of counterbalance applied to the cutting
decks.
Auto Idle: (Yanmar diesel engines only) When the engine is running and the
machine is in neutral, the engine will automatically return to the low idle setting
after the set time delay. When the engine is running and the machine is not in
neutral , the engine will automatically return to the high idle setting after the set
time delay. Use the left/right button (as indicated by the
the screen) to select 8, 10, 15, 20, or 30 seconds or the auto idle feature can
be set to O .
FF
g189671
1. About menu
2. Left/right button
3. Down button
The about screen (Figure
number, and software revision for the machine. If the correct passcode (PIN) has
been entered (refer to the Protected Menus in the
the Toro Electronic Controller (TEC), InfoCenter, and engine ECU software is
displayed, and the CAN−bus status will be visible. Press the down button to scroll
through the screen items (as indicated by the
information found in the about screen can only be edited by your Toro Distributor.
To return to the previous screen, press the menu/back button (as indicated by
the at the bottom of the screen).
5–21)).
Figure 144
4. Menu/back button
5. About items
144) identifies the machine model number, serial
Page 5–23
at the bottom of
Settings Screen (page
at the bottom of the screen). The
Electrical System: InfoCenter Display
5–21)),