How To Use; Installing The Sim Card; Led Indicator - MeiTrack TC68S User Manual

MEITRACK TC68S/TC68SG User Guide
2 USB port
3 Power button
4 GSM indicator (green)
5 GPS indicator (blue)
6 SOS button
7 Vehicle's OBD II connector

5 How to Use

5.1 Installing the SIM Card

To install the SIM card, open the SIM card cover, insert the card (card chip facing down), and close the card cover.
Note:

Power off the device before installing the SIM card.

Ensure that the SIM card has sufficient balance.

Ensure that the phone card PIN lock has been closed properly.

Ensure that the SIM card in the device has subscribed the caller ID service if you want to send an SMS.

5.2 LED Indicator

To start the device, press and hold down the power button for 2 seconds. Once the device is plugged into the
vehicle's OBD II connector, it will make a sound.
GPS Indicator (Blue)
Copyright © 2019 Meitrack Group All rights reserved.
Used for charging the device, configuring parameters, and upgrading
software.

When the device is turned off, press and hold down the button for
2 seconds. The device will make a sound, indicating that it will be
turned on.

When the device is turned on, press and hold down the button for
2 seconds. The device will make a sound, indicating that it will be
turned off.

In the sleep mode, press the button to wake the device up. Then
the power indicator will blink for 10 seconds.
Indicates GSM status. For details, see section 5.2 "LED Indicator."
Indicates the GPS status. For details, see section 5.2 "LED Indicator."
Press and hold down the button for 2 seconds in the case of emergency.
The device will beep once.
The device will also dial three authorized phone numbers in sequence. It
will stop dialing when one phone number answers. Meanwhile, the
device will send an SMS with positioning information to authorized
phone numbers. If the GPRS function is enabled, the device will send a
GPRS message to the server.
In the sleep mode, press the button to wake the device up.
Plug the device into the vehicle's OBD II connector. The device is always
powered on by vehicle's battery.
- 8 -