Table of Contents
Advertisement
9
Configuration
The MA
248i
control. The connected device is normally configured via the service interface of the MA with
the help of a suitable configuration program.
The respective configuration programs – e.g. for bar code readers the BCL-Config, for RFID
devices the RF-Config etc. – and the associated documentation is provided on the Leuze
home page www.leuze.com in the respective Download area:
Notice!
In order to display the help texts, a PDF viewer program (not included in the delivery contents)
must also be installed. For important information on configuring and on the configurable
functions, please refer to the description of the respective device.
9.1
Connecting the service interface
The RS 232 service interface is connected after opening the device cover of the MA
via the 9-pin Sub-D and a cross-wired null modem cable (RxD/TXD/GND). For connection,
see chapter "Service interface (internal)" on page 37.
The service interface is activated with the help of the service switch and establishes a direct
connection to the connected device with the "DEV" (Leuze device) or "MA" (gateway)
setting.
9.2
Reading out information in Service mode
After starting up in the "RUN" switch position, set the service switch of the MA to the
"MA" position.
Now start one of the following terminal programs: e.g., BCL, RF, BPS Config.
Alternatively, you can also use the Windows tool "Hyperterminal".
Start the program.
Select the correct COM port (e.g., COM1) and set the interface as follows:
Leuze electronic
is configured using the GSD or GSDML file via the device manager of the
MA
248i
Configuration
248i
45
Advertisement
Table of Contents
