Rotary Switch S4 For Device Selection - Leuze electronic MA 248i Original Operating Instructions

Status displays and operational controls
For further information on the corresponding options, see chapter 4.4 "Operating modes".
8.2.5

Rotary switch S4 for device selection

The S4 rotary switch is used to select the Leuze end device.
Figure 8.5:
The following switch positions are assigned to the Leuze devices:
Leuze device
Standard setting
Other RS 232 devices such as
KONTURflex QUATTRO
BCL 8
BCL 22
n.c.
BCL 300i, BCL 500i,
BCL 600i
BCL 90, BCL 900i
LSIS 122, LSIS 222
The gateway is set via the switch position on the Leuze device. If the switch position is
changed, the device must be restarted, since the switch position is only queried after
switching off completely and then restarting the device.
Notice!
In switch position "0", a distance of >20ms must be maintained between two telegrams so
they can be distinguished from one another.
The parameters of the Leuze end devices are described in chapter 16.
44
Rotary switch for device selection
Switch position Leuze device
0 LSIS 4x2i, DCR 202i
1 Hand scanner
RFID (RFI xx,
2
RFM xx, RFU xx)
3 BPS 8
ODS 9, ODSL 30, ODSL 96B,
4
BPS 300i
5 MA 3x
6 Reset to factory setting
MA 248i
Switch position
7
8
9
A
B
C
F
Leuze electronic