Table of Contents
Advertisement
16.6
LSIS 122, LSIS 222 (S4 switch position 6)
Specifications for the serial interface
Default parameter
Baud rate
Data mode
Handshake
Protocol
Frame
Specifications for Command mode
To activate the Command mode, bit 0 must be set to 1 in control byte 0.
For further information, see chapter 11.1.3 "Command mode", figure 11.2.
Control bit
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Recommended settings
• Input module: dependent on the number of digits of the 2D code that is to be read.
With an 18-digit code (+ 2 bytes of status bytes), for example, the input module with
20 bytes is advisable.
• Output module: 4 bytes
Leuze electronic
LSIS 122, LSIS 222
9600
8N1
no
framing protocol without acknowledgment
<STX> <Data> <CR> <LF>
Meaning
Version query
Activation/Deactivation of reading gate: 12h/14h (LSIS 122 only)
Activation of reading gate (LSIS 222 only)
Deactivation of reading gate (LSIS 222 only)
Specifications for Leuze end devices
MA
248i
Corresponds to
serial command
(ASCII)
i
<DC2> / <DC4>
<SYN>T<CR>
<SYN>U<CR>
93
Advertisement
Table of Contents
