Table of Contents
Advertisement
Commissioning and configuration
12.4.3 Overview of the project modules
When using PROFINET-IO modules, the parameters are assembled dynamically, i.e., only
the parameters that were selected by the activated modules are changed.
The MA
248i
parameters are defined outside of modules and are thus linked to the base module (DAP).
In the current version, several modules are available for use. A device module (DAP, see
Permanently defined parameters/device parameters) is used for basic configuration of the
MA
248i
and is permanently integrated into the project. Further modules may be included
into the project according to requirements and application.
The modules fall into the following categories:
• Parameter module for the configuration of the MA 248i.
• Status or control modules that influence the input/output data.
• Modules that may include both parameters and control or status information.
A PROFINET-IO module defines the existence and meaning of the input and output data.
In addition, it defines the necessary parameters. The arrangement of the data within a
module is defined.
The composition of the input/output data is defined via the module list.
The MA
248i
the MA 248i. The interpreter for processing the data is adapted to the module structure
during initialization.
The same applies for the input data. Using the module list and the defined module proper-
ties, the input data string is formatted and referenced to the internal data.
During cyclic operation, the input data is then passed on to the controller.
During the startup or initialization phase, the MA
(usually 0).
Notice!
The modules can be grouped together in any order in the engineering tool. Note, however,
that many MA
of these data.
The MA
248i
otherwise, the MA
The MA
248i
can be used for both the input data and for the output data.
The specific limits of the individual modules of the MA
The following module overview shows the characteristics of the individual modules:
74
has parameters (device parameters) that must always be present. These
interprets the incoming output data and triggers the appropriate reactions in
248i
modules contain related data. It is important to maintain the consistency
offers different modules. Each of these modules may only be selected once;
248i
ignores the configuration.
checks its max. permissible number of modules. A maximum of 1024 bytes
248i
sets the input data to an initial value
248i
MA
248i
are declared in the GSD file.
Leuze electronic
Advertisement
Table of Contents
