Table of Contents
Advertisement
For further information on the corresponding options, see chapter 4.4 "Operating modes".
8.2.5
Rotary switch S4 for device selection
The S4 rotary switch is used to select the Leuze end device.
Figure 8.5:
The following switch positions are assigned to the Leuze devices:
Leuze device
Standard setting
Other RS 232 devices such as
KONTURflex QUATTRO
BCL 8
BCL 22
BCL 32
BCL 300i, BCL 500i
BCL 90
LSIS 122
The gateway is set via the switch position on the Leuze device. If the switch position is
changed, the device must be restarted, since the switch position is only queried after
switching off completely and then restarting the device.
Note!
In switch position "0", a distance of >20 ms must be maintained between two telegrams so
they can be distinguished from one another.
The parameters of the Leuze end devices are described in chapter 16.
Additional parameters such as the baud rate and data mode can be configured via the GSD
file with the "USE GSD settings" enable function. The data frame and, if necessary, the length
are specified via the switch position.
Leuze electronic
Rotary switch for device selection
Switch position
Status displays and operational controls
Leuze device
0
LSIS 4x2i
1
Hand scanner
RFID (RFI xx,
2
RFM xx, RFU xx)
3
BPS 8
AMS,
4
ODS 9, ODSL 30, ODSL 96B
5
MA 3x
6
MA
204i
Switch position
7
8
9
A
B
C
39
Advertisement
Table of Contents
