Dante Operation - ZeeVee ZyPer4K User Manual

ZyPer4K

Dante Operation

It is expected that the user is familiar with Dante and the use of Dante networks. It is beyond the
scope of this document to provide Dante training.
The Dante Transmitter found in the ZyPer4K decoder will automatically insert the Down-mix
Audio stream that it is receiving onto the Dante Network. Refer to the ZyPer Management
Platform User Guide for details on streaming audio/video from an encoder to a decoder.
https://cdn2.hubspot.net/hubfs/4316736/SUPPORT/USER-GUIDES/ZyPer-Management-
Platform-User-Manual.pdf
Network settings are the same as standard ZyPer4K encoders/decoders.
Some switches may require additional settings to work with a Dante network. For example the
Netgear M4300 series requires settings detailed at the following location:
https://kb.netgear.com/000060205/M4300-Configuration-Guide-for-Dante-Audio-Devices
The user should consult the documentation for the switch provider being used.
In Dante Controller the device will appear as a Transmitter with the name ZV-XXXXXX-YYYYYY
XXXXXX - Represents the final bytes of the ZyPer4K MAC Address
YYYYYY - Represents the final bytes of the Dante AVIOAI2 Transmitter MAC Address
Note that the device can be renamed in Dante Controller software.
Below are screen shots from Dante Controller.
Z4K Dante User Manual Page 7 of 18