Table of Contents
Advertisement
Lane Approached (Flashing Yellow Thick Line,
Solid Yellow Thin Line/Flashing Yellow Telltale)
NOTE:
The LaneSense system operates with the
similar behavior for a right lane departure.
Changing LaneSense Status
The LaneSense system settings can be config-
ured through the Uconnect system screen.
Follow these steps to change the LaneSense
settings:
1. Press the "Controls" button located on the
bottom of the Uconnect touchscreen display.
2. Press the "Settings" button.
3. Press the "Safety & Driving Assistance" but-
ton.
When in the Safety & Driving Assistance screen,
you can configure the intensity of the torque
warning and the warning zone sensitivity (early/
late) through the personalization settings.
92
NOTE:
• When enabled the system operates above
37 mph (60 km/h) and below 112 mph
(180 km/h).
• Use of the turn signal suppresses the
warnings.
• The system will not apply torque to the
steering wheel whenever a safety system
engages. (anti-lock brakes, traction con-
trol system, electronic stability control,
forward collision warning, etc.)
PARKSENSE REAR PARK
ASSIST — IF EQUIPPED
The ParkSense Rear Park Assist system pro-
vides visual and audible indications of the dis-
tance between the rear fascia and a detected
obstacle when backing up, e.g. during a parking
maneuver. Refer to "ParkSense System Usage
Precautions" in this section for limitations of this
system and recommendations.
ParkSense will retain the last system state (en-
abled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
ParkSense can be active only when the gear
selector is in REVERSE. If ParkSense is en-
abled at this gear selector position, the system
will remain active until the vehicle speed is
increased to approximately 7 mph (11 km/h) or
above. The system will become active again if
the vehicle speed is decreased to speeds less
than approximately 6 mph (9 km/h).
ParkSense Sensors
The four ParkSense sensors, located in the rear
fascia/bumper, monitor the area behind the ve-
hicle that is within the sensors' field of view. The
sensors can detect obstacles from approxi-
mately 12 inches (30 cm) up to 79 inches (200
cm) from the rear fascia/bumper in the horizon-
tal direction, depending on the location, type
and orientation of the obstacle.
ParkSense Warning Display
The ParkSense Warning screen will only be
displayed if Sound and Display is selected from
the Uconnect System. Refer to "Uconnect Set-
tings" in "Understanding Your Instrument Panel"
for further information.
The ParkSense Warning screen is located
within the instrument cluster display. It provides
visual warnings to indicate the distance between
the rear fascia/bumper and the detected ob-
stacle. Refer to "Instrument Cluster Display" in
"Understanding Your Instrument Panel" for fur-
ther information.
ParkSense Display
When the vehicle is in REVERSE, and an
obstacle has been detected, the warning display
will turn on indicating the system status.
Advertisement
Chapters
Table of Contents
