Dodge Charger SRT 392 2017 Operating Information Manual page 46

buckled seat belt interferes with the child re-
straint installation, instead of buckling it behind
the child restraint, route the seat belt through the
child restraint belt path and then buckle it. Do
not lock the seat belt. Remind all children in the
vehicle that the seat belts are not toys and that
they should not play with them.
WARNING!
• Improper installation of a child restraint to
the LATCH anchorages can lead to failure
of the restraint. The child could be badly
injured or killed. Follow the child restraint
manufacturer's directions exactly when in-
stalling an infant or child restraint.
• Child restraint anchorages are designed to
withstand only those loads imposed by
correctly-fitted child restraints. Under no
circumstances are they to be used for adult
seat belts, harnesses, or for attaching
other items or equipment to the vehicle.
What is the weight limit (child's weight + weight of the
child restraint) for using the Tether Anchor with the seat
belt to attach a forward facing child restraint?
Installing Child Restraints Using The
Vehicle Seat Belt
Child restraint systems are designed to be se-
cured in vehicle seats by lap belts or the lap belt
portion of a lap/shoulder belt.
WARNING!
• Improper installation or failure to properly
secure a child restraint can lead to failure
of the restraint. The child could be badly
injured or killed.
• Follow the child restraint manufacturer's
directions exactly when installing an infant
or child restraint.
The seat belts in the passenger seating posi-
tions are equipped with a Switchable Automatic
Locking Retractor (ALR) that is designed to
keep the lap portion of the seat belt tight around
the child restraint so that it is not necessary to
use a locking clip. The ALR retractor can be
"switched" into a locked mode by pulling all of
the webbing out of the retractor and then letting
the webbing retract back into the retractor. If it is
locked, the ALR will make a clicking noise while
the webbing is pulled back into the retractor.
Frequently Asked Questions About Installing Child Restraints With Seat Belts
Weight limit of the Child
Always use the tether anchor when using the seat belt to
install a forward facing child restraint, up to the recom-
Restraint
mended weight limit of the child restraint.
Refer to the "Automatic Locking Mode" descrip-
tion in "Switchable Automatic Locking Retrac-
tors (ALR)" under "Occupant Restraint Systems"
for additional information on ALR.
Please see the table below and the following
sections for more information.
Lap/Shoulder Belt Systems For Installing
Child Restraints In This Vehicle
Automatic Locking Retractor (ALR) Locations
ALR = Switchable Automatic Locking Retractor
Top Tether Anchorage Symbol
43