Changing Lanesense Status; Parkview Rear Back Up Camera - Dodge RAM 2500 2022 Owner's Manual

210 STARTING AND OPERATING
C L S S
HANGING ANE ENSE TATUS
The LaneSense system has settings to adjust the
intensity of the torque warning and the warning
zone sensitivity (Early/Medium/Late) that you can
configure through the Uconnect system
Ú page 247.
NOTE:
When enabled the system operates above

37 mph (60 km/h) and below 112 mph
(180 km/h).
Use of the turn signal suppresses the warnings.

The system will not apply torque to the steering

wheel whenever a safety system engages
(Anti-Lock Brakes, Traction Control System,
Electronic Stability Control, Forward Collision
Warning, etc.).

PARKVIEW REAR BACK UP CAMERA

The ParkView Rear Back Up Camera allows you to
see an on-screen image of the rear surroundings of
your vehicle whenever the gear selector is put into
REVERSE. The image will be displayed on the
Uconnect display along with a caution note to
"Check Entire Surroundings" across the top of the
screen. After five seconds this note will disappear.
The ParkView Camera is located in the center of
the tailgate handle.
NOTE:
Removing the tailgate will disable the rearview
camera function.
Manual Activation Of The Rear View
Camera
1. Press the "Controls" button located on the
bottom of the Uconnect display.
2. Press the "Backup Camera" icon to turn the
Rear View Camera system on.
When the vehicle is shifted out of REVERSE (with
Camera delay turned off), the rear Camera mode is
exited and the previous screen appears again.
When the vehicle is shifted out of REVERSE (with
Camera delay turned on), the rear Camera image
will be displayed for up to 10 seconds after shifting
to another gear, unless the vehicle speed exceeds
8 mph (13 km/h), the transmission is shifted into
PARK, the ignition is placed in the OFF position, or
the touchscreen button "X" to disable display of
the Rear View Camera image is pressed.
Whenever the Rear View Camera image is
activated through the "Backup Camera" button in
the Controls menu, and the vehicle speed is
greater than, or equal to, 8 mph (13 km/h), a
display timer for the image is initiated. The image
will continue to be displayed until the display timer
exceeds 10 seconds.
NOTE:
If the vehicle speed remains below 8 mph

(13 km/h), the Rear View Camera image will be
displayed continuously until deactivated via the
touchscreen button "X", the transmission is
shifted into PARK, or the ignition is placed in the
OFF position.
The touchscreen button "X" to disable display of

the camera image is made available ONLY when
the vehicle is not in REVERSE.
Cargo Camera Icons — If Equipped
Backup Camera Touchscreen Button
Cargo Camera Touchscreen Button
AUX Camera Touchscreen Button
If equipped with a Cargo Camera, a touchscreen
button is made available to indicate the current
active Camera image being displayed whenever
the Rear View Camera image is displayed.