Changing Lanesense Status; Parkview Rear Back Up Camera - Dodge DURANGO 2019 User Manual

• When the LaneSense system senses the lane
has been approached and is in a lane depar-
ture situation, the left thick lane line flashes
yellow (on/off) and the left thin line remains
solid yellow. The LaneSense telltale
changes from solid yellow to flashing yellow.
At this time torque is applied to the steering
wheel in the opposite direction of the lane
boundary.
For example: If approaching the left side of the
lane the steering wheel will turn to the right.
NOTE:
The LaneSense system operates with the simi-
lar behavior for a right lane departure.

Changing LaneSense Status

The LaneSense system has settings to adjust
the intensity of the torque warning and the
warning zone sensitivity (early/late) that you can
configure through the Uconnect system screen.
Refer to "Uconnect Settings" in "Multimedia"
in your Owner's Manual for further information.
156
NOTE:
• When enabled the system operates above
37 mph (60 km/h) and below 112 mph
(180 km/h).
• Use of the turn signal suppresses the warn-
ings.
• The system will not apply torque to the steer-
ing wheel whenever a safety system engages
(anti-lock brakes, traction control system,
electronic stability control, forward collision
warning, etc.).
PARKVIEW REAR BACK UP
CAMERA
Your vehicle is equipped with the ParkView Rear
Back Up Camera that allows you to see an
on-screen image of the rear surroundings of
your vehicle whenever the gear selector is put
into REVERSE. The image will be displayed on
the Navigation/Multimedia radio display screen
along with a caution note to "check entire sur-
roundings" across the top of the screen. After
five seconds this note will disappear. The
ParkView camera is located on the rear of the
vehicle above the rear license plate.
When the vehicle is shifted out of REVERSE
(with camera delay turned off), the rear camera
mode is exited and the navigation or audio
screen appears again.
Manual Activation Of The Rear View Camera
1. Press the "Controls" button located on the
bottom of the Uconnect display.
2. Press the "Backup Camera" button to turn
the Rear View Camera system on.
NOTE:
The ParkView Rear Back Up Camera has pro-
grammable modes of operation that may be
selected through the Uconnect System.
Refer to "Uconnect Settings" in "Multimedia"
in your Owner's Manual for further information.
When the vehicle is shifted out of REVERSE
(with camera delay turned off), the rear camera
mode is exited and the previous screen appears
again. When the vehicle is shifted out of RE-
VERSE (with camera delay turned on), the cam-
era image will continue to be displayed for up to
ten seconds after shifting out of REVERSE un-
less the vehicle speed exceeds 8 mph
(13 km/h), the vehicle is shifted into PARK, the