Modes Of Operation; Seats; Power Seats - If Equipped - Dodge Charger SRT 392 2017 Operating Information Manual

WARNING!
Rear Cross Path (RCP) is not a Back Up Aid
system. It is intended to be used to help a
driver detect an oncoming vehicle in a park-
ing lot situation. Drivers must be careful when
backing up, even when using RCP. Always
check carefully behind your vehicle, look
behind you, and be sure to check for pedes-
trians, animals, other vehicles, obstructions,
and blind spots before backing up. Failure to
do so can result in serious injury or death.

Modes Of Operation

Three selectable modes of operation are avail-
able in the Uconnect System. Refer to
"Uconnect Settings/Customer Programmable
Features" in "Understanding Your Instrument
Panel" for further information.
Blind Spot Alert Lights Only
When operating in Blind Spot Alert mode, the
BSM system will provide a visual alert in the
appropriate side view mirror based on a de-
tected object. However, when the system is
operating in Rear Cross Path mode, the system
will respond with both visual and audible alerts
when a detected object is present. Whenever an
audible alert is requested, the radio volume is
reduced so that the alert can be better heard.
60
Blind Spot Alert Lights/Chime
When operating in Blind Spot Alert Lights/Chime
mode, the BSM system will provide a visual alert
in the appropriate side view mirror based on a
detected object. If the turn signal is then acti-
vated, and it corresponds to an alert present on
that side of the vehicle, an audible chime will
also be sounded. Whenever a turn signal and
detected object are present on the same side at
the same time, both the visual and audio alerts
will be issued. In addition to the audible alert the
radio (if on) volume will be reduced so that the
alert can be better heard.
When the system is in RCP, the system shall
respond with both visual and audible alerts
when a detected object is present. Whenever an
audible alert is requested, the radio volume is
reduced so that the alert can be better heard.
Blind Spot Alert Off
When the BSM system is turned off there will be
no visual or audible alerts from either the BSM
or RCP systems.
NOTE:
The BSM system will store the current operating
mode when the vehicle is shut off. Each time the
vehicle is started the previously stored mode will
be recalled and used.

SEATS

Seats are a part of the Occupant Restraint
System of the vehicle.
WARNING!
• It is dangerous to ride in a cargo area,
inside or outside of a vehicle. In a collision,
people riding in these areas are more likely
to be seriously injured or killed.
• Do not allow people to ride in any area of
your vehicle that is not equipped with seats
and seat belts. In a collision, people riding
in these areas are more likely to be seri-
ously injured or killed.
• Be sure everyone in your vehicle is in a
seat and using a seat belt properly.
Power Seats — If Equipped
On models equipped with power seats, the
switch is located on the outboard side of the
seat near the floor. Use this switch to move the
driver's seat up, down, forward, rearward or to
recline the seatback.