Mitel SMarT-1 EuroRoute Compact Installation & Programming Manual page 13

Installing the Compact Connection Leads
Safety
8346-003-115-B
Issue 1, August 1999
There are two RJ11cables supplied with the Compact. Using these two cables, follow the
listed steps to install your Compact.
• Looking at the Compact, you will see three connectors; two of which are used to
connect the supplied cables.
• Connect one of the cables to the middle connector on the Compact. This connector
is identified on the back of the unit as, "To Telephones".
• Connect the other cable to the end connector on the Compact. This connector is
identified on the back of the unit as, "To Phone Socket".
• Unplug your telephone from the wall socket.
• Connect your telephone to the middle connector labeled, "To Telephone".
• Connect your wall socket to the end connector labeled, "To Phone Socket".
To Phone Socket
Optional power supply
The Compact Dialer operates from a nominal 230 +/- 10% VAC supply. The power supply
unit used with this apparatus must be fully compliant with the EEC Low Voltage Directive
(73/23/EEC).
Safety Status of Ports
PSU TNV †
NTP Ports TNV †
† TNV is defined in EN 60950: 1992.
Connectivity
The Compact is intended to be placed in between the telephone wall outlet and the user's
telephone. There are two RJ11 telecom cables, an RJ11 for connection to the Exchange
and an RJ11 for connection to the resident's telephone or answering machine, that are
used to connect the unit.
Network Approvals
Note 1: The equipment has been approved to commission decision 98/482/EC (CTR 21)
for pan_European single terminal connection to the Public Switched Telephone Network
(PSTN). However, due to differences between the individual PSTNs provided in different
countries, the approval does not, or itself, give an unconditional assurance of successful
operation on every PSTN network termination point. In the event of problems, you should
contact your equipment supplier in the first instance.
Note 2: This product should work in a satisfactory manner when used in the countries
listed in the European Telecommunications Standard Institute (ETSI) Guide EG 201 121.
The countries listed in the guide are Germany, Greece, Portugal, Spain and Switzerland.
Note 3: The SMarT-1 EuroRoute Dialer is suitable for connection to a Public Switched
Telephone Network supporting Multi-Frequency dialling.
Loop disconnect dialling may ONLY be used in EC Memberstates, which have NO
additional regulatory requirements for Loop Disconnect dialling for products which are
approved to CTR 21 (e.g. UK). For more details, contact your local Regulatory Notified
body.
Hardware Installation
To Telephone
Pow er Supply C onnector
Compact Dialer - 13