Mitel SMarT-1 EuroRoute Compact Installation & Programming Manual page 12

Hardware Installation
Checking whether the Compact will work on your line
Warning
Connecting a Power Supply
Power Failure
Emergency Number
12 - Compact Dialer
• Pick up the telephone handset and dial the Bad Line Test code ( 0002).
• If you hear a continuous tone you may hang up. The Compact will now call the
management centre for programming. Please wait 10 minutes before using your
telephone.
• If you do NOT hear a continuous tone or you get a recorded message from the
PSTN, you will need to contact your maintainer to obtain a power supply.
• Until a power supply is attached, the Compact will not route calls or Call Home to
obtain a program. You may, however, still use your telephone with the Compact
connected.
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations.
• Use caution when installing or modifying telephone lines.
• Connect the power supply to the power supply jack.
• Plug the power supply into a power outlet, and verify that the Mains switch is on.
• Lift the telephone handset, and check for dial tone.
• Repeat the installation process with the power supply connected.
• If you experience problems, please call your maintainer.
Note: Before disconnecting the power supply, in installations requiring a power supply,
disconnect the telephone network connections first.
If a power failure occurs while the optional power supply is being used, the user's
telephone equipment will be connected directly to the Exchange line. The user will still
have access to the telephone network, but the Compact will not screen or route calls. This
statement does not apply to the installations that do not require the optional power supply.
Note: Although this equipment can use either loop disconnect or DTMF signalling, only
the performance of DTMF signalling is subject to regulatory requirements for correct
operation. It is therefore strongly recommended that the equipment is set to DTMF
signalling for access to public or private emergency services. DTMF signalling also
provides faster call set up.
The emergency number 112 is hard coded. Regardless of any programming that may
conflict with this number, the Compact will dial the emergency number directly to the
Exchange and cut through.
8346-003-115-BA
Issue 1, August 1999