Table of Contents
Advertisement
Miniature Integrated Stepper Motor Controller(
Max starting speed and max cessation speed has been described in front section. The unit
of MMS and MMD are pps.
In addition, notice that, if you want to store the value of set acceleration, deceleration,
maximum start speed and maximum instantaneous stopping speed in the EEPROM, you
need to send an instruction STO0; after sending the above instructions. Otherwise, after
power failure and restarted, the parameter values will be restored to the factory value. In
addition, the instruction STO0; affects the real-time performance of the control. See the
Chapter 11.0 for details for more details.
Figure7-12: Two modes to Set the of Acceleration Rate
Speed
Max. Start Speed
Current Speed
7.9 Enable/disable Advanced Motion Control Module (MCFG)
Advanced Motion Control Module can be enabled or disabled by setting the CM bit of
MCFG (MCFG<10>). Setting the CM bit (MCFG<CM>=1) will enable the module and
clearing the CM bit (MCFG<CM>=0) will disable the advanced motion control module. (For
details of setting, please refer to Section 5.4 Master Configuration Register.) Meanwhile,
the AM and DM bit of MCFG also defines the input methods of acceleration/deceleration.
7.10 Instruction List
The following table shows the instructions mentioned in this chapter, the detail of those
instructions is descriped at the end of the document.
Instruction Description
BLC;
BLC;
MAC;
MAC;
MDE;
MDE;
MMD;
MMD;
MMS;
MMS;
UI Robot Technology Co. Ltd.
（1）Acc. Period
Set backlash compensation value η
Check backlash compensation value
Set acceleration rate η
Check acceleration rate
Set deceleration rate η
Check deceleration rate
Set maximum cessation speed η
Check maximum cessation speed
Set maximum starting speed η
Check maximum starting speed
M4220170607EN
Desired Speed
（2）Acc. Rate (Slope)
)
Closed-loop
T（时间）
Page
64
65
75
76
80
81
83
84
85
86
Page 41
Advertisement
Table of Contents
