Setting The Water Inlet - Viega Multiplex Trio E Instructions For Use Manual

3.3.2

Setting the water inlet

Starting the water inlet
Stopping the water inlet
Setting the water temperature
Multiplex Trio E fitting, electronic mixing unit
In the factory settings, the following values have been assigned to the
memory spaces:
Memory space 1: 12 °C, 100 % water stream strength, 45 min. inflow
n
time
Memory space 2: 25 °C, 100 % water stream strength, 45 min. inflow
n
time
Memory space 3: 38 °C, 100 % water stream strength, 45 min. inflow
n
time
The water inlet takes place pursuant to one of three saved programs:
Press briefly 1 x = program memory space 1
n
Press briefly 2 x = program memory space 2
n
Press briefly 3 x = program memory space 3
n
If you do not wish to use one of the pre-programmed settings, start one
of the programs and change temperature and inflow time individually.
Operating status
Action Briefly press the control element 1 x.
Result The water starts to flow in according to the
settings of program memory space 1.
Operating status
Action Briefly press the control element 1 x.
Result The water inlet stops.
The fitting has a temperature safeguard at 38 °C to exclude
scalding. For information on how to bypass the temperature
safeguard, see
safeguard" on page 27.
„OFF"
„ON"
Ä Chapter 3.3.3 „Disabling the temperature
Handling
26 from 38