TRANSMISSION
•
Fit the spacer and wheel axle and tighten the nuts fully
working in crosswise sequence.
•
Fit the dust cover with internal circlip in the front of the
swing arm.
•
Fit the spring in the relative bore in the cardan coupling
and apply grease to hold it in position.
•
Insert the cardan coupling into the swing arm through
the dust boot.
•
Take care to ensure that the spring does not fall out of
place when inserting the sleeve into the coupling.
IMPORTANT Now reassemble the swing arm as follows:
•
Screw in the pin on the right-hand side until it protrudes
from the swing arm sufficiently to hold the shim.
•
Insert the swing arm into the transmission case cover.
•
Tighten the left-hand pin fully down until the shim on
the right-hand side is located against the bearing fitted
to the transmission case cover.
•
Snug the pin on the right-hand side without tightening.
•
Articulate the swing arm to ensure that it moves freely
without play.
6 - 10
NEVADA 750 i.e.