MOTO GUZZI Nevada Classic 750 ie 2004 Workshop Manual page 109

TRANSMISSION
• Fit the gear-hollow shaft assy., cover and relative
spacers and gaskets to the transmission case and
temporarily screw down the fixing screws.
•
Equip the gear holder hollow shaft with a Universal
puller tool having central spacers in such a way as to
maintain the gear so that it exerts slight pressure
towards the brake disk side.
•
Turn the pinion in the direction of run while braking the
gear so that the rotation takes place under load and
the contact areas are marked on the pinion tooth
surfaces.
•
If the contact is correct the marking on the pinion teeth
should appear as shown. Note that the pinion is viewed
from the driving shaft side
•
If the contact markings are as shown here, the gear is
too close to the pinion axis of rotation: move the gear
back by increasing the thickness of the shim
6 - 26
NEVADA 750 i.e.