ASSEMBLY
③
②
Photo 1
Optional
Cord Hanger
Photo 2
Optional
Cord Hanger
Shown
With Cord
®
ACCU-SCOPE
(continued)
④
②
①
Fig. 4
①
Fig. 5
73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com
EXC-350 MICROSCOPE SERIES
LED Illuminator
IMPORTANT: The LED illuminator bulb is
pre-installed. These instructions are only
necessary should the need arise for a
replacement lamp.
Align the orientation pin ① and power pin ②
on the light source to the oriented holder ③ and
power socket ④, then push the light source in
until it is flush (see Fig. 4).
Connecting the Power Cord
IMPORTANT: Use care when storing the
power cord so that it does not bend or twist.
Make sure the power switch is at "0"(OFF)
before connecting.
①
Insert the connector
into the power socket
Insert the other connector securely into an
electrical outlet.
The microscope uses a universal power
supply so it may be used in any voltage
range between 90 ~ 240v when used with the
appropriate line cord.
An optional cord hanger can be installed on
your microscope for simple and easy
storage. (see Photos 1 & 2)
of power cord securely
②
, (see Fig. 5).
10