Accu-Scope EXC-350 Series Manual page 10

ASSEMBLY
②
①
②
③
®
ACCU-SCOPE
(continued)
①
③
Fig. 1
③
②
Fig. 2
①
Fig. 3
73 Mall Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com
EXC-350 MICROSCOPE SERIES
Condenser
The condenser was installed and centered by our
technicians prior to delivery. If the condenser needs
to be re-installed or adjusted in the future, rotate the
coarse focusing knob
highest position (see Fig. 1).
Rotate the condenser up-down knob
bracket of condenser to the suitable position.
Fully loosen the condenser lock-screw
Insert the condenser into the hole of the stand
according to the directional arrow, until the
condenser is even with the stand, and then rotate
the condenser to make sure the iris diaphragm
control lever faces forward.
Tighten the lock-screw ③ of the condenser, then
raise the condenser with the up-down knob to the
highest position.
Objectives
Rotate the coarse focusing knob
stage to a suitable position (see Fig. 2).
Install the objectives into the objective nosepiece
from the lowest magnification to the highest in a
clockwise direction from the rear.
Eyepieces
Remove the eyepiece caps
②
Insert the eyepiece
until it touches the surface of the eyepiece tube
Repeat above for the other eyepiece (see Fig. 3).
①
to raise the stage to the
②
to lower the
③
.
①
to lower the
①
.
into the eyepiece tube
9
②
③
.