Table of Contents
Advertisement
3
Programming the Siren-based system
(without control panel)
The Siren is the heart of the system. All components must be recognised by the Siren.
Entering Learn mode:
1
• Press and hold
(A short beep will follow with the outside LEDs flashing once.)
i
System is now in learning mode for 3 minutes.
Proceed to the following steps to add in
additional devices (20 devices maximum) within
this time period.
If device learning takes more than 3 minutes and
the learn mode expires, the siren learn button will
need to be pressed again to add more devices.
Adding devices:
2
i
When any device is learnt-in, the siren will beep
once and the outside LEDs will flash once in
acknowledgement.
Remember to press any buttons and keys firmly
for 1 second to send a learn-in radio signal.
PRESS
Key Pad
(All keys should be pressed in quick succession.)
1 Press
Panic button A
note that the default PIN code is 0000).
(The LED will now be flashing. System is now in setting mode)
2 Press
Panic button A
(The keypad will confirm with two fast flashes that it is in "Siren
as master" mode.)
3 Press
Panic button A
signal, then press
(The Key Pad LED will now stop flashing. If not, press "disarm"
twice again)
for 1 second.
Siren learn button
PRESS
PRESS
ale
Y
and enter
PIN code
and enter
8
then
to send learn-in
1
twice to quit.
disarm
Exiting Learn mode:
3
• Press the
(The middle LED will flash once and there will be a single
short beep to indicate that normal Siren operation has been
resumed.)
Adjusting Alarm ringing duration:
4
• Dip switch 3 determines the alarm ringing duration
length. Switch left for 4 minutes or right for 10
minutes (default) Siren duration.
Enable/disable interference detection:
5
• Set Dip switch 2 for interference detection. Switch
left to enable and right to disable (default).
i
This unit is equipped with the latest type of
radio receiver using AM radio technology. If the
system is armed any criminal attempt to interfere
detector transmissions will trigger an alarm.
If the alarm is frequently triggered by interference
there may be high levels of unusual radio signals
PRESS
in your area. Some kinds of electronic equipment
can generate this kind of radio interference.
In the unlikely event of you experiencing problems
with interference, it is recommended that you
switch interference detection off.
PRESS
Programming is now finished and the system is
ready to be installed.
(please
to exit the learn mode
Siren Learn button
5
Advertisement
Table of Contents
