Adding Accessories - Yale Smart Living HSA6210-R Installation, Programming, Operating

Adding accessories

To provide additional protection you can add extra Door/Window Contacts, PIRs, Key Fobs,
Key Pads, Panic Buttons and Smoke Detectors. These are available separately from your
local stockist.
i
Adding devices for the first time
See section 3 (page 5) for first time system
installation.
Adding devices to an already installed
system
The installed system will be controlled by either a
Key Fob(s) or a Key Pad(s).
Key Pad
1 Enter Setting mode: Press Panic button A
followed by the PIN code
(Indicated by a continuously flashing LED.)
2 Switch OFF system tamper: Press Panic button
A followed by 2
(The Siren will beep in response.)
3 Enter learn mode: Press Panic button A followed
by 4 .
(The Siren will beep and flash in response.)
4 LEARNING: Press device learn/test buttons (see
section 3, step 2) to trigger learning-in signals.
(The Siren will beep and flash when each device is learnt in.)
5 Exit learn mode: When all the devices have been
learnt in, press Panic button A and 5 to quit learn
mode.
6 Switch ON system tamper: Press Panic button A
and 3 to rearm tamper protection.
7 Exit Setting mode: Press Disarm twice to exit.
(The Key Pad LED will now stop flashing.)
Key Fob
1 Press the Arm and Home buttons together and
continuously for 5 seconds until the LED stops
flashing, to switch off the tamper while installing
the new device.
(The Siren will beep in response.)
2 Press the Home and Emergency buttons together
and continuously for 5 seconds until the LED stops
flashing.
(The Siren will beep and flash in response.)
3 Press device learn/test buttons (see section 3,
step 2) to trigger learning-in signals.
(The siren will beep and flash when each device is learnt in.)
4 When all the devices have been learnt-in press and
hold the Disarm button to quit learn mode.
5 Press the Arm and Emergency buttons together
and continuously for 5 seconds until the LED stops
flashing to rearm tamper protection.
11