Control Panel Menu System In Detail; Entering Programming Mode; System Test; Set Up - Yale IA-210 Full User Manual

7. Control Panel Menu System in Detail

Entering Programming Mode

The programming mode is for you to configure
the system, and make any changes to the pre-set
functions.
If the system is in Disarmed (Alarm off) mode, follow
the steps below to enter the programming mode.
1. Press pq key on the Control Panel.
The screen will prompt you to enter the PIN code.
2. Key in your PIN code within 30 seconds.
Note
• Press 3 to clear the entered PIN. If the code field
is empty, it will return to the Alarm Off screen.
3. Press 3 to continue.
The following message is displayed for 2 seconds.
P r o g r a m
M a k e
4. Then the Programming Main Menu will typically be
displayed.
Note
• The cursor is indicated by 2 arrows on both sides
of the selected option. It can be moved up and
down by pressing pq respectively.
5. The following items can be selected:
· Set-up
· Test
·
System log
· Contactless Tags
· Up/Download
6. After making a selection by moving the cursor
to the desired item, press 3 to confirm the
selection. The display will show you the individual
programming screen accordingly. Selecting P will
return to the Alarm Off screen.
Important Note
• In programming mode, if no key is pressed within
5 minutes, the panel will exit the programming
mode and return to the Alarm Off screen.
16
16
m e n u
a s e l e c t i

System Test

When System Test is selected, you will be given 4
different options: Sensor Test, External Siren (test),
Panel Siren (test) and Phone alert.
Sensor Test:
Three beeps will sound during a screen self test.
This allows you to test the system without causing
an alarm. To test the Control Panel is receiving a
signal, do one of the following on each accessory
that you want to test:
1. Key Pad:-
Press button 8 and 9 together on the Key Pad
2. For all other Accessories:-
Press the test/learn button on the accessories
A chime will sound and the display will show you
which device is transmitting.The upper right corner
will show the radio signal strength ranging from 1 to
9 (strongest). Relocate the sensor if this is below 5
(unstable).
o n
Ext. Siren and Panel Siren (test)
• The External Siren and Control Panel internal siren
can be tested by pressing 3 when prompted.
Press 3 once more to stop the Siren.
Phone alert
:
• Select this option for a test call via phone dialer.

Set Up

This option allow to tailor the system setting to the
user needs. You will be given 4 different options:
• Devices
• Part Arming
• Phone Alert
• Advanced Settings
The Part-Arm (Home Arm) mode allows the home
to be partially armed so that no one can get inside
without first disarming the system. However, the
person inside the house can move freely around
without triggering the alarm. Part arm mode is
usually used to protect the ground floor when you
are upstairs in bed.
To enable Home Arm, you will first need to choose
the sensors to be ignored during this mode. It would
typically be the bedroom PIR etc if you want to arm
your system during the night.
Selecting this option, the screen will display with a
brief description then press V (Tick) to confirm and
the screen will show you a message to press the
test button on devices you would like to exclude on
Part arm mode.
•
: